– 13 –
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
Touch the
CLOCK
pad.
Touch the number pads.
Touch the
START
pad.
Make sure the clock is set to the
correct time of day.
To Set the Timer
Touch the
KITCHEN TIMER
ON/OFF
pad.
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch
2, 4
and
5
in that order. If you make a
mistake touch the
KITCHEN TIMER
ON/OFF
pad and begin again.
Touch the
START
pad.
After touching the
START
pad,
SET
disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the timer reaches
:00
, the
control will beep 3 times followed
by one beep every 6 seconds until
the
KITCHEN TIMER ON/OFF
pad
is touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by
touching the
KITCHEN TIMER ON/OFF
pad,
then touch the number pads until the
time you want appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the
KITCHEN TIMER ON/OFF
pad
and then touching the number pads to
enter the new time you want.
To Cancel the Timer
Touch the
KITCHEN TIMER ON/OFF
pad twice.
Your control will allow you to lock out the surface
burners, oven burners and control panel so they
cannot be activated.
To lock/unlock the controls:
Turn all surface burners off.
Touch and hold the
RANGE
LOCK-OUT
pad for 3 seconds until
the display shows
LOC ON
.
To unlock the control, touch and
hold the
RANGE LOCK-OUT
pad for
3 seconds until the display shows
LOC OFF
.
When this feature is on and the touch
pads are touched, the control will beep
and the display will show
LOC ON
.
■
The control lock-out mode affects all controls.
No controls will work when this feature is
activated.
■
The adjustment will be retained in memory
after a power failure.
Range Lock-Out
(on some models)
