49-2001565 Rev. 0
Installation Instructions
1.
5$1*(72335(3$5$7,21&RQW
Ŷ
Attach the rangetop in the cabinet opening by
driving four screws into the countertop. Install
2 screws per side using preferred hole options
based on countertop construction. If countertop
is wooden, start by drilling pilot holes with a
GULOOELW'ULYHWKHSURYLGHGVFUHZVLQWR
the holes to attach.
NOTE:
There should be an unobstructed vertical
gap of .25" under the rangetop to allow for proper
FRPEXVWLRQDQGFRROLQJDLUIORZ'RQRWEORFNWKLV
gap.
2.
*$66833/<&RQW
&RQQHFWDSURSDQHVXSSO\OLQHZLWKD´)ODUH
Female connection to the regulator in the upper
left rear corner of the cabinet
Tighten the gas line to the regulator using 2
wrenches.
IMPORTANT:
Leave adequate space around
the gas supply pipe in case of bend or damage
during installation. Make sure the gas supply
pipe cannot contact any moving parts after
installed.
When using pressures greater than ½ psi
N3DWRWHVWWKHJDVVXSSO\V\VWHPRIWKH59
GLVFRQQHFWWKHUDQJHWRSDQGLQGLYLGXDOVKXWRII
valve from the gas supply piping. When using
SUHVVXUHVRIòSVLN3DRUOHVVWRSUHVVXUH
test the gas supply system, simply isolate the
rangetop from the gas supply system by closing
WKHLQGLYLGXDOVKXWRIIYDOYH
2. GAS SUPPLY
WARNING
Fire Hazard: Do not use a
IODPHWRFKHFNIRUJDVOHDNV
WARNING
Explosion Hazard: Do not
H[FHHGIWOEVRIWRUTXHZKHQPDNLQJJDV
OLQHFRQQHFWLRQV2YHUWLJKWHQLQJPD\FUDFN
the pressure regulator resulting in fire or
explosion hazard.
WARNING
*DVOHDNVPD\QRWEH
detected by smell alone. Gas suppliers
recommend your purchase and install an
UL approved gas detector. Install and use
in accordance with the manufacturer's
instructions.
Gas Pressure Regulator
<RXPXVWXVHWKHSURSDQHJDVSUHVVXUH
regulator supplied with this rangetop. For proper
operations the inlet pressure to the regulator
should be as follows:
0LQLPXPSUHVVXUH´RI:DWHU&ROXPQ
0D[LPXPSUHVVXUH´RI:DWHU&ROXPQ
INST
ALLA
TION INSTRUCTIONS
3URSDQH6XSSO\
Line Connection
