TM
Dimensions (in inches)
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.
PNRQ15F – GE Profile
™
Reverse Osmosis Filtration System
Specification Created 02/06
280105
3/8 Drain Tubing
RO Product
Water Mounted
Through Sink
7"
15"
11"
10.5"
Hot
Cold
Disposer
Reverse Osmosis System
Sink
P-Trap
Reservoir
Drain
Outlet
Inlet
11" Dia.
minimum 4" from bottom of sink
to top of horizontal “T” connection
Installation and Parts Information
Note:
R.O. System can be installed up to 30 feet from point-of-use/faucet.
Note:
Can be installed under counter (as shown), in basement, or other convenient location. Before
installing, see installation instructions packed with product for complete details.
Replacement Membranes, Pre- and Post-Filters
Call SmartWater Services, toll-free, 800.952.5039 for convenient ordering.
GE Reverse Osmosis Models PNRQ15F Series are tested and certified to ANSI/NSF Standard 58 for
TDS and cyst reduction. See Performance Data Sheet for details.
Caution:
Do not use with water that is microbiologically unsafe or of unknown quality, without
adequate disinfection before or after the system. Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cysts. This reverse osmosis unit contains a replaceable
membrane cartridge treatment component critical for effective removal of Total Dissolved Solids. The
water should be tested periodically to verify that the system is performing satisfactorily.
Independently Tested
The GXRM10G has been independently tested by NSF and WQA, two of the most highly recognized
testing institutions in the water treatment industry. The PNRQ20F and PNRQ15F have been
independently tested by NSF. Product performance testing details by each test facility are specified
on the Performance Data Sheet (inside the product box).
