Before you call for service…
Consumer S
uppor
t
Tr
oubleshooting Tips
Car
e and Cleaning
Operating Instructions
Safety Instructions
30
Problem
Possible Causes
What To Do
“Crackling” or
This is the sound of the
•
This is normal.
“popping” sound
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking
Excessive soil.
•
Touch the
CLEAR/OFF
pad. Open the windows to
during a clean cycle
rid the room of smoke. Wait until
LOCKED
goes off.
Wipe up the excess soil and reset the clean cycle.
Oven door will not
Oven too hot.
•
Allow the oven to cool below locking temperature.
open after a clean cycle
Oven not clean after
Oven controls not properly set.
•
See the
Using the self-cleaning oven
section.
a clean cycle
Oven was heavily soiled.
•
Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“LOCKED” flashes
The self-clean cycle has been
•
Close the oven door.
in the display
selected but the door is not
closed.
“LOCKED” is on
The oven door is locked
•
Touch the
CLEAR/OFF
pad. Allow the oven to cool.
when you want
because the temperature
to cook
inside the oven has not
dropped below the
locking temperature.
“F—and a number
You have a function error code.
•
Disconnect all power to the oven for
or letter” flash
at least 30 seconds and then reconnect power.
in the display
If the function error code repeats, call for service.
“LOCKED” appears
The controls have
•
See the
Control Lock
section to unlock.
in the oven display
been locked.
Control signals after
You forgot to enter a
•
Touch the
BAKE
pad and desired temperature or
entering cooking time
bake temperature or
the
SELF CLEAN HI/LO
pad and desired clean time.
or start time
cleaning time.
Display goes blank
A fuse in your home may be
•
Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is in the
•
See the
Special features of your oven control
section.
black-out mode.
Display flashes
Power failure.
•
Reset the clock.
Unable to get the
Oven control pads were
•
The
BROIL HI/LO
and
BAKE
pads must be touched
display to show “SF”
not touched properly.
at the same time and held
for 3 seconds
.
“Probe” appears
This is reminding you to
•
Enter a probe temperature.
in the display
enter a probe temperature
after plugging in the probe.
Troubleshooting Tips
