GEAppliances.com
27
Sa
fe
ty
In
str
uc
tio
ns
O
pe
ra
tin
g I
ns
tru
cti
on
s
Sa
fe
ty
In
str
uc
tio
ns
O
pe
ra
tin
g I
ns
tru
cti
on
s
Ca
re
a
nd
C
lea
nin
g
Tro
ub
les
ho
ot
in
g T
ip
s
Co
ns
um
er
S
up
po
rt
It’s a good idea to wipe the control panel after
each use of the oven. Use a damp cloth to
clean or rinse. For cleaning, use mild soap
and water or a 50/50 solution of vinegar and
water. For rinsing, use clean water. Polish dry
with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven
cleaners on the control panel—they will
damage the finish.
The control knobs may be removed for easier
cleaning.
Make sure the knobs are in the
OFF
positions
and pull them straight off the stems for
cleaning.
The knobs can be cleaned in a dishwasher
or they may also be washed with soap and
water. Make sure the insides of the knobs are
dry before replacing.
Replace the knobs in the
OFF
position to
ensure proper placement.
Pull the knob straight off the stem.
Control Panel and Knobs
Warming Drawer Rack
(on some models)
Clean the rack with detergent and water.
After cleaning, rinse the rack with clean water
and dry with a clean cloth.
Removable Warming Drawer
(on some models)
Most cleaning can be done with the drawer in
place. However, the drawer may be removed
if further cleaning is needed. Use soap and
warm water to thoroughly clean.
To remove the warming drawer:
Pull the drawer straight out until it stops.
Press the left rail release up and press
the right rail release down, while pulling
the drawer forward and free.
To replace the warming drawer:
Place the left drawer rail around the
inner left rail guide and slide it in
slightly to hook it.
Place the right drawer rail around the
inner right rail guide and slide it in
slightly to hook it.
Slide the drawer all the way in.
NOTE:
For models with an electric
warming drawer, before performing
any adjustments, cleaning or service,
disconnect the range electrical power
supply at the household distribution panel
by removing the fuse or switching off the
circuit breaker. Make sure the warming
drawer heating element is cool.
On glass cooktop models, the oven is vented
through an opening at the rear of the
cooktop.
On coil cooktop models, the oven is vented
through an opening under the right rear
surface unit.
Never cover the opening with aluminum foil
or any other material.
Oven Vent
