GE Reason H49
Technical Manual
H49/EN M/C22
139
NTP
The following values can be set in the NTP configuration:
command
parameter
Description
Values
ntp
-a
Sets the IP address of remote NTP server
-c
Disables or enables the NTP client
enable,
disable
-p
Sets the poll rate of NTP client
-s
Disables or enables the local NTP server
enable,
disable
PTP
The following values can be set in the IEEE1588-v2 PTP configuration (VLAN, PCP,
Mode).
ptp [-m <mode>] [-s <steps>] [-p1 <priority1>] [-p2
<priority2>] [-a <domain>] -o -S –i
command
parameter
Description
Values
ptp
-m
Sets the IEEE1588-v2 operating mode
disable, ordinary, boundary
-f
Sets the IEEE1588-v2 profile
power_2011, default_12
-l
Sets the IEEE1588-v2 delay
disabled, <p2p> TC peer-to-peer,
<e2e> TC end-to-end
-s
Sets the IEEE1588-v2 steps
1, 2
-p1
Sets the IEEE1588-v2 prority1
0 to 255
-p2
Sets the IEEE1588-v2 priority2
0 to 255
-a
Sets the IEEE1588-v2 domain
0 to 255
-n
Sets VLAN used for PTP
0 to 4094
-c
Sets PCP used for PTP
0 to 7
-o
Sets the PTP synchronization to slave mode.
Redundancy Mode
The following values can be set to configure the Reason H49 Redundancy function:
command
parameter
Description
Values
redundancy
-l
Sets the interlink ID
HSR-PRP-A,
HSR-PRP-B
-n
Sets the network ID
1 to 6
-a
Sets redundancy supervision MAC address
Summary of Contents for Reason H49
Page 10: ...Technical Manual GE Reason H49 10 H49 EN M C22 1 2 Ordering Options ...
Page 157: ......