10
Code Search
If your device does not respond after you have tried
all the codes for your brand, or if your brand is not
listed, try searching for your code by following these
steps.
1. Manually turn on the device (
TV
,
VCR
, etc.) to be
controlled.
2. Press and hold the
SETUP button until the
red indicator stays on, then release the
SETUP button.
3. Press and quickly release the desired
device button (
TV, VCR, etc.). The red
indicator blinks off once.
4. Press the
ON•OFF button repeatedly
(up to 300 times) until the device
to be controlled turns off. The red
indicator blinks off with each button
press.
Most users will store VCR codes under the
VCR button,
Cable codes under
CABLE, etc. If (for example) you want to
store a VCR code under
CABLE, first follow the procedure
for Direct Code Entry (previous page) and press
CABLE in
step 2 of Direct Code Entry, then enter ANY VCR code in step
3 of Direct Code Entry. Then follow the steps above for Code
Search.
Note: Code Search starts from the currently stored three
digit number under that mode. Sometimes the first code
that “works” with your device may only allow limited
functionality (e.g. the MENU button might not work). There
may be a code that performs more functions. Continue the
code search process until the best code is found.
5. Press and release
ENTER to install the
code.
SETUP
