Chapter 7
Page no. 666
JC-ELE-A-022.fm
GE Healthcare
Senographe DS
Revision 1
Service Information and Procedures Class A 2385072-16-8EN
Job Card ELE A022 - Declare Network Hosts
3. The following field must be completed if the remote host device is a review workstation:
-
Query Retrieve
: Select
Patient
,
Study
, or
No Provider
; (refer to the Review Workstation DICOM
3.0 Conformance Statement).
Note:
RWS (U60) is not a Q/R provider (it cannot be queried), but some remote stations such as Rad-
works or AW4.0 (Seno Advantage) are Q/R providers.
4. The following field must be completed if the remote host device is an Archival device:
-
Storage Commitment
: Set to
Yes
if the Archival device DICOM 3.0 Conformance Statement lists
this feature; set to
No
if the Statement does not list the feature.
•
If
Storage Commitment
is set to
No
; set
Message Send
to
Yes
if you want an
S
to appear in the
Report Status column of the Study or Exam list when a study has been sent to the Archival
device.
•
If
Storage Commitment
is set to
Yes
; the fields
Application Entity Title
,
Network Address
, and
Port
Number
in the lower part of the window are highlighted. You must complete these fields, even if
the information is the same as that already entered. This is necessary to allow the possibility of
images being sent to one remote host and committed to another.
5. On completion, click the
Save
button to update and close the window.
Note:
Network Remote Hosts are not updated in the
/etc/inet/hosts
file, but are found in the file
/export/
home/sdc/Prefs/SdCRHosts
. For this reason, it is not possible to use
ping
,
telnet
,
spray, and
sim-
ilar commands using the hostname. The IP address must be used instead. For example, to ping
the MR operator console from the workstation, do not use /
usr/sbin/ping MR01_OC0
. Instead, use
the IP address, e.g.,
/usr/sbin/ping 192.9.200.1
.
Though it is not mandatory to declare hosts in the
/etc/inet/hosts
file when using the SdC NET pro-
tocol, it is recommend you to do it in any case.
You are returned to the
Remote Host Selection
window.
6. Click the
Done
button (on V1/V2 Control Stations) or
OK
button (on V3/V4 Control Stations) to close
the
Remote Host Selection
window.
7. For Senographe systems using ADS versions 31.27 and above you must reload the Senographe
system IP Filters so that the newly declared network host has access through the Senographe sys-
tem firewall via the DICOM protocol. To do this, perform the following sub-steps:
a. From behind the Browser, launch a command window (see
Launching a Command Line Window
).
A command window appears.
b. Execute the
IPFreload.sh
script, by entering:
IPFreload.sh
c. When the
Password:
prompt appears requesting you to enter the root password, enter:
operator
An
End of script
message appears. The newly declared network host can now access the Senog-
raphe system.
7-2-1
Declaring a DICOM IC (Independent Console)
A new protocol has been implemented in order to solve some problems with the IC current software
Release 5.5. The problem was that echo, delay, repetition, and inversion times display were being multi-
plied by 1000.
Declare the host as any other Dicom3 host, but select the
IC Dicom3.0
protocol.
