Chapter 8
Page no. 64
8-browser.fm
GE Healthcare
Senographe DS Acquisition System
Revision 1
Operator Manual 5307907-3-S-1EN
Browser
2
Browser restart
If it is necessary to restart (reset) the Browser, proceed as follows:
•
Place the cursor in the title bar at the top of the Browser window.
•
Use the left mouse button to drag the window down, leaving a blank space on the screen above the
window.
•
Place the cursor in the blank space; click the right button.
•
Select
Restart Browser
from the drop-down menu.
If
Network
,
Printing
, or
Save
operations are in progress, a warning
box is displayed, allowing you to proceed with the restart or to cancel
it. Jobs in progress are interrupted and may be lost when the Browser
is restarted. Network transfers are stopped, but are automatically
retried after the restart. Printing and save operations are stopped, and
must be launched again after the restart. Note that interrupted save
operations to a CD-R may result in a partially saved file on the disk;
the disk will be unusable and must be replaced before the operation is
repeated.
3
System Shutdown
•
To shut down the Senographe DS system, click on the
Power off
icon
at the lower right of
the Browser window. Power is removed from the Senographe DS Gantry and Generator; the Control
Station follows a shutdown procedure lasting about two minutes, designed to ensure that no informa-
tion is lost.
4
Log off
•
This function may be used to prevent access by unauthorized persons to the system and locally
stored patient data, especially between two acquisitions.
•
To use the function, click the
Logoff
button icon at the top right of the screen. The sys-
tem returns to the login screen (see Chapter
, section
). Follow the usual login procedure to resume operation.
•
The system administrator can configure the system to log off automatically after a cho-
sen delay.
Network queue (non empty)
Restart Browser
OK
Cancel
Restart Browser
FOR
TRAINING
PURPOSES
ONLY!
NOTE:
Once
downloaded,
this
document
is
UNCONTROLLED,
and
therefore
may
not
be
the
latest
revision.
Always
confirm
revision
status
against
a
validated
source
(ie
CDL).
