GE Healthcare
Senographe DS
Revision 1
Service Information and Procedures Class A 2385072-16-8EN
Job Card ELE A065 - Trackball Configuration
Page no. 789
Chapter 7
JC-ELE-A-065.fm
5. Press and release button 1 and wait for the trackball to stop beeping.
•
Button 6:
Right click
1. Press and hold buttons 1 and 6 until the trackball beeps.
2. Press and hold buttons 2 and 5. Wait until the trackball beeps and ensure that you release both
buttons before the beep ends (the beep lasts 2 seconds).
3. Press and release button 6 and wait for the trackball to stop beeping.
4. Press and release button 3 and wait for the trackball to stop beeping.
5. Press and release button 1 and wait for the trackball to stop beeping.
7-3
Trackball Setup Checks
The following procedure is suggested as a check for correct trackball setup:
1. Start up the system as usual.
2. With the Browser window displayed on the AWS screen, press the keyboard
Front
key on V1/V2/V3
Control Stations, or the keyboard
Alt
+
Tab
keys together on V4 Control Stations until the
Iconbox
window appears.
3. Double-click the trackball button 4 to open the
Console
window.
•
If the Console window does not open, repeat the setup procedure for button 4.
4. To check that buttons 3 and 4 are correctly set for
left click
:
With the cursor in the
Console
window, press the keyboard
Control
key.
Keep the
Control
key pressed while you do each of the following checks:
•
Press button 3
:
if the
Main Options Menu
does not appear, repeat the setup procedure for button 3.
•
Release button 3
:
if the
Main Options Menu
does not close, repeat the setup procedure for button 3.
•
Press button 4
:
if the
Main Options Menu
does not appear, repeat the setup procedure for button 4.
•
Release button 4
:
if the
Main Options Menu
does not close, repeat the setup procedure for button 4.
5. To check that buttons 2 and 5 are correctly set for
middle click
:
With the cursor in the
Console
window, press the keyboard
Control
key.
Keep the
Control
key pressed while you do each of the following checks:
•
Press button 2
:
if the
VT Options Menu
does not appear, repeat the setup procedure for button 2.
•
Release button 2
:
if the
VT Options Menu
does not close, repeat the setup procedure for button 2.
•
Press button 5
:
if the
VT Options Menu
does not appear, repeat the setup procedure for button 5.
•
Release button 5
:
if the
VT Options Menu
does not close, repeat the setup procedure for button 5.
