GE Spacemaker DDP1400S, Use And Care Manual

HOW TO 

 YOUR DRYER

 reduce the risk of fire, electric shock, or injury to persons,

read the 

 SAFETY 

 before operating this appliance.

 , , 

.

0

0

.

Push To 

Check the Lint 

Clean the lint filter each time the dryer is used. Always

2. Lightly squeeze the body as shown

be sure the lint filter is in place.

while 

 the cover off.

A

Do not run the dryer with the lint screen

3. ROLL lint off the screen with

loose, damaged, blocked or missing. Doing so

your fingers. 

Do not 

 or

can 

cause overheating, damage fabrics and be a

wash the screen.

fire hazard.

4. Replace the cover on the body of

The lint screen is located inside

the-lint screen.

\

the dryer drum, on the back wall.

Squeeze 

5. Before replacing the lint screen,

To clean:

pull cover off

remove any lint from the wire mesh

1. 

Use the finger holes to pull the lint

on the back wall (behind the lint screen).

—

screen straight out.

6. Push the lint screen straight back until it snaps

Pull straight out

into place.

Sort and Load the Clothes

Good sorting for the dryer begins at the washer.

If you do mix various types of fabrics in your load,

Generally, if clothes are sorted right for washing,

set the controls for the lighter-weight fabrics and

they’re sorted right for drying. See the How to Sort

remove when dry. Reset controls for the remaining

the Clothes section.

heavier fabrics

Set the Controls

See the Suggested Fabric and Drying Selections guide.

 Cycle Selector.

Turn the Cycle Selector to the desired cycle setting.
The selector may be turned in either direction.

 Button.

Press 

the Start button to start the dryer. (Opening

the door during operation stops the dryer. To
restart, close the door and press the Start button.)

NOTE: 

Drying times will vary according to the type of heat used (electric,

natural gas or 

 gas), size of load, types of fabrics, wetness of clothes and

condition of exhaust ducts.

6