7
GEApplances.com
D
Temperature
Select the water temperature for the wash and rinse cycles. Always follow fabric manufacturer’s care label or instructions
when laundering.
PerfecTemp
senses the incoming water temperature and adjusts the fill water to obtain a more precise temperature range
for all wash temperatures. For example, in a COLD wash selection, some warm water may be added to reach a temperature
needed to better dissolve detergents. Often, detergents are not completely dissolved in very cold water, especially in cooler
climates.
During winter months, when the water entering your home is colder, or for locations with very cold water year round, use the
PerfecTemp
plus COLD to help dissolve powdered detergents and to improve the cleaning of your clothes.
The
TAP COLD
feature turns the
PerfecTemp
feature on your washer off, and uses your household tap water temperature for a
COLD wash. This can provide energy savings by reducing the amount of hot water used in your wash.
E
Load Size
Loosely load clothes no higher than the top row of holes in the washer basket.
AUTO LOAD SENSING
- This selection automatically provides the correct amount of water suited to the size and type of load
placed in the unit.
B
FABRIC SOFTENER
Set this option when adding fabric softener to the washer.
F
START
Press
START
to begin the cycle. With the lid closed pressing
START
again will PAUSE the cycle and
STATUS
lights will blink. To
continue the cycle, close the lid and press
START
again. The water fill will continue with the lid opened, except when
AUTO
LOAD SENSING
is selected as the load size. (The lid
must be closed
to continue filling when
AUTO LOAD SENSING
is selected.)
If the lid is opened during the cycle, the cycle will
PAUSE
and the
STATUS
lights will blink. To resume the cycle, close the lid and
press
START
.
If the machine is paused for more than 24 hours, the cycle will be cancelled. To stop the cycle, turn the Cycle Selector to the
OFF
position.
C
STATUS lights
The
STATUS
lights show the stage the washer is in. When the selector knob is set to a new cycle, the
STATUS
lights will flash
momentarily, showing the stages the cycle will go through.
STATUS light
Illuminates
ON
When the fabric softener option has been selected.
WASH
When the washer is in the wash portion of the cycle.
RINSE
When the washer is in the rinse portion of the cycle.
SPIN
When the washer draining and/or spinning.
LID LOCKED
When the washer lid is locked. This feature prevents the lid from being opened while the
washer is in the spin cycle or coasting to a stop.
NOTE:
If the STATUS lights are blinking, the operation of the washer has been paused. To resume operation
press the
START
button (the lid must be closed).
