This microwave oven is shipped assembled for top
exhaust. You will need the exhaust adaptor for
installation in the rear wall opening. To remove the
exhaust adaptor from the microwave oven:
Remove tape securing damper.
2
Slip the damper
out of the track
on the blower
frame by pressing
and twisting
both ends.
INSTALLATION OVERVIEW
B1.
Prepare Rear Wall
B2.
Remove Exhaust Adaptor
B3.
Attach Mounting Plate to Wall
B4.
Prepare Top Cabinet
B5.
Adjust Blower
B6.
Mount the Microwave Oven
IMPORTANT NOTES:
•
Make sure the screws for the
blower motor and blower plate
are securely tightened when
they are reinstalled. This will
help to prevent excessive
vibration.
•
Make sure the motor wiring has
been properly routed and secured,
and that the wires are not pinched.
Remove and save the screw that holds the blower
plate to the microwave. Lift off the blower plate.
Back of Microwave
Back of
Microwave
Raise damper flap.
Installation Instructions
15
3
4
1
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
B1.
You need to cut an opening in the rear wall for
outside exhaust.
•
Read the instructions on the REAR WALL
TEMPLATE.
•
Tape it to the rear wall, lining up with the holes
previously drilled for holes A and B in the wall
plate.
•
Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
REMOVE EXHAUST ADAPTOR
B2.
OUTSIDE BACK EXHAUST
(Horizontal Duct)
B
Blower Plate
Blower Plate
