GE Reason Switches
Chapter 5
– Interfaces
REASON SWITCHES-TM-EN-3
119
show ip interface ?
It will be displayed all of the options allowed a
t the interface menu. “brief” will be the
only choice. Then, type:
show ip interface brief
The command above is the full command to view all IP interfaces configured at the
equipment. After typing it at the command line, press enter.
This online help can be used anytime when configuring the equipment through this
interface. If necessary, the user can access it as a guide to perform the configuration
through SSH protocol interface.
6.3
Telnet
Telnet configuration interface can be used through Ethernet (electrical or optical)
connections. To use this protocol, it is necessary to know the IP of the equipment to
be accessed. If used, this interface requires a computer with Telnet-aware software
to communicate with Reason Switches.
Allowed commands at the main menu are:
clear
reset functions;
configure
enter configuration mode;
copy
copy from source to destination;
delete delete one file in flash: file system;
dir
directory of all files in flash: file system;
disable turn off privileged commands;
do
to run exec commands in configuration mode;
dot1x IEEE standard for port-based access control;
enable turn on privileged commands;
erps
Ethernet Ring Protection switching;
exit
exit from EXEC mode;
failsafe configure failsafe relay;
firmware
firmware upgrade or swap;
Summary of Contents for T1000
