GE Reason Switches
Chapter 7
– Configuration
192
REASON SWITCHES-TM-EN-3
Save: save configuration at the Running Config;
Reset: undo changes made locally at the Running Config;
Cancel: cancel changes made locally at the Running Config.
o
DSCP Based
: enable DSCP-based QoS function at the port. If DSCP
bits are allowed, this checkbox allows the switch to use this
information at the IP packet to perform QoS functions. Checkbox
selected means DSCP-based QoS enabled, and checkbox empty
means disabled.
After one of the configurations described before is changed, there are buttons that
allows the user to save or discard the configurations.
o
Save
: save configuration at the Running Config;
o
Reset
: undo changes made locally at the Running Config.
11.2
Port Policing
Port Policing menu allows configuring traffic limits for the ports.
If one configuration is desired to be applied at all ports, then the row “*” should be
used, that is, configuration done in
the “*” row will be replied to all ports. Possible
configurations are as follows.
o
Port
: shows the ports to be configured at this row;
o
Enabled
: enable Port Policing function at the port. Checkbox
selected means function enabled, and checkbox empty means
disabled;
o
Rate
: indicates the maximum allowed traffic on that port. Traffic
rates at the port higher than this field are not allowed if function is
enabled, then traffic close to the limit will start packet losing based
on the QoS configured. Allowed values are integer values and limits
depend on the Unit used. Range of 100 to 1,000,000 is allowed
when kbps or fps units are used. Range of 1 to 32,000 is allowed
when Mbps or kfps units are used;
o
Unit
: indicates which unit should be used with Rate value to limit
traffic. Allowed values are kbps, Mbps, fps and kfps;
o
Flow Control
: enable flow control usage at the port. Flow control
function is defined at the 802.3x standard, and defines methods to
equipment send pause frames instead of drop data when there is
congestion in the network. Checkbox selected means function
enabled, and checkbox empty means disabled.
After one of the configurations described before is changed, there are buttons
that allows the user to save or discard the configurations.
Summary of Contents for T1000
