GE
Lumination
Light Guide
Forming Instructions
(GEXNLG15, GERDXNLG15, GEPOXNLG15, GEYAXNLG15, GELGXNLG15,
GEGLXNLG15, GEBLXNLG15)
Tetra
®
Contour
LED Lighting System
Remove the protective film from the light guide.
1
Mark the light guide at the required length, adding
0.5 in. (13mm) for every 16 in. (406mm) to account
for shrinkage during the forming process.
2
Cut the light guide to the required length using a
hacksaw, chop saw (cross cut or veneer blade only),
band saw, or other appropriate plastic cutting tool.
Take the proper safety precautions when cutting the
light guide.
3
Fill the entire light guide channel with the Silicone
Bend-Aid(s) (GEXNBA) and press into place. Bend-Aid
must be installed prior to heating and forming.
NOTE:
The Silicone Bend-Aid (GEXNBA) is reusable.
4
Step 1:
Preparation
imagination at work
Silicone Bend-Aid
