Installation Guide
12
Volt
Tetra
®
Wet Location
Power
MAX
LED Lighting System
GEPM71-W1, GEPM50-W1, GEPM41-W1, GEPM32-W1
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save These Instructions
Use only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
Prepare Electrical Wiring
Electrical Requirements
•
Acceptable for use in dry, damp and wet locations.
•
The grounding and bonding of the LED Driver shall
be done in accordance with National Electric Code (NEC)
Article 600.
•
Follow all National Electric Codes (NEC) and local codes.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment
is operated in a commercial environment . This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to
correct the interference at his own expense.
This Class [A] RFLD complies with the Canadian standard
ICES-005. Ce DEFR de la classe [A] est conforme à la NMB-005
du Canada.
imagination at work
WARNING/AVERTISSMENT
RISK OF ELECTRIC SHOCK RISQUES DE DÉCHARGES ÉLECTRIQUES
•
Turn power off before inspection, installation or removal.
•
Coupez l
’
alimentation avant
l’inspection, l’installation
ou le déplacement .
•
Properly ground Tetra
®
power supply enclosure.
•
Assurez-vous de correctement mettre à terre l
’
alimentation électrique Tetra
®
.
RISK OF FIRE RISQUES
D’INCENDIE
•
Use only UL approved wire for input/output connections.
• N’utilisez
que des fils approuvés par UL pour les entrées/sorties de connexion.
Minimum size 18 AWG (0.82mm
2
) Taille minimum 18 AWG (0.82mm
2
)
•
Follow all NEC and local codes.
•
Respectez tous les codes NEC et codes locaux.
