T
C
Measure Point
Components - Tetra
®
SNAP Accessories (optional)
Tetra SNAP Rail (GEDSRL08-3)
Tetra Snap SS Plastic Clip (GESSPC-3)
Tetra Snap SS Metal Clip (GESSMC-3)
Tetra SNAP Frame Endcap (GEDSFE-3)
Tetra SNAP Socket Endcap (GEDSSE-3)
Tetra SNAP Dual Rail Socket Cap (GESSDR-3)
Tetra SNAP T-connector (GEDSTC-3)
Tetra SNAP Interconnector (GEDSIC-3)
Tetra PowerMAX is also compatible with the following Tetra SNAP Rail components.
See https://products.currentbyge.com/led-signage-lighting for further details and install instructions.
1
1
2
2
3
3
4
4
5
5
6
6
7
8
8
7
UL approved 18 AWG (0.82 mm
2
) supply wire
UL approved 22-14 AWG (0.33-2.08 mm
2
) wire connectors or
22-18 AWG (0.33-0.82 mm
2
) in-line/IDC connectors
#6 (M3) screws, 1/8 inch (3.2 mm) rivets, or electrical grade RTV
silicone or equivalent
Weather box GEXNWB2 (optional)
Tetra® 24 Volt Power Supply
Tetra® PowerMAX LED modules
Electrical grade RTV silicone:
• Momentive RTV 6700 Series Silicone Rubber Adhesive Sealant
• Momentive White Blanc RTV 162 Silicone Rubber Adhesive
Sealant-Electrical Grade
• Dow Corning 3140 - Non-Corrosive Flowable (clear)
• Dow Corning 3145 - Non-Corrosive Nonflowable (clear or gray)
• Dow Corning RTV 748 Non-Corrosive Sealant-White
1
1
2
2
3
3
4
4
5
5
6
6
7
7
Components
Tips
• For optimal light uniformity in halo-lit applications the Tetra
®
LED modules should be mounted on UL recognized plastic
and the light output from the Tetra
®
LED system should be directed back into the sign enclosure. This will allow for uniform
backlighting of the sign and will provide simple mounting for the Tetra
®
LED system.
• A best practice for the supply wire at the point at which it is brought into the sign is to have a drip loop on the inside of the
letter to keep water from collecting on the Tetra
®
LED strip.
• These products are not required to be enclosed or protected from weather.
Tetra
®
PowerMAX
Installation Guide
3
