4-10
745 Transformer Management Relay
GE Multilin
4.2 745PC SOFTWARE INTERFACE
4 HUMAN INTERFACES
4
4.2.7 USING 745PC
a) SAVING SETPOINTS TO A FILE
Saving setpoints to a file on the local PC is accomplished as follows:
1.
If the local PC is not connected to a 745 relay, select the
File > Properties
menu item. The dialog box shown below
appears, allowing for the configuration of the 745PC software for the options ordered for a particular 745 relay. 745PC
needs to know the correct options when creating a setpoint file so that setpoints that are not available for that particular
relay are not downloaded.
Figure 4–8: FILE PROPERTIES WINDOW
2.
Select the installed options from the drop down menus. After configuration, select the
File > Save As
menu item. This
launches the following dialog box. Enter the file name under which the file will be saved in the
File Name
box or click
on any of the file names displayed. All 745 setpoint files should have the extension
.745
(for example,
xfrmr01.745
). Click
OK
to proceed.
Figure 4–9: SAVING SETPOINTS
3.
The software reads all the relay setpoint values and stores them to the selected file.
