GFK-2721A
Chapter 2 Installation
2-5
2
Installing the Module on a DIN Rail
The PROFINET Scanner and connecting carriers must be installed on
the same section of 35mm x 7.5mm DIN rail. The rail must have a
conductive (unpainted) finish for proper grounding. For best
resistance to vibration, the DIN rail should be installed on a panel
using screws spaced approximately 6 inches (5.24cm) apart.
Modules snap easily onto the DIN rail. No tools are required for
mounting or grounding to the rail.
Removing the Module from the DIN Rail
1. If the module is attached to the panel with a screw, remove the screw.
2. Slide the module along the DIN rail away from the other modules until the connector
disengages.
3. With a small flathead screwdriver, pull the DIN rail latch tab outward while tilting the other
end of the module down to disengage it from the DIN rail.
