GE M
EDICAL
S
YSTEMS
D
IRECTION
FK091075, R
EVISION
04
V
IVID
3N P
RO
/E
XPERT
S
ERVICE
M
ANUAL
8-138
Section 8-8 - Peripherals
8-8-4-4 Color Video Printer Installation - Procedure1
(cont’d)
18) Connect the RGB and SYNC cables, Color Printer Remote cable, and AC power cable (hanging out
of the Bottom Metal Cover slot - see
Figure 8-117 "Color Printer Cables through Metal Bottom Cover
Slot" on page 8-135
), to the Color Video Printer, as shown in the diagram in
Figure 8-122 "Color
Video Printer Connection Cables" on page 8-138
.
19.)Position the Color Video Printer against the rubber stoppers at the rear of the shelf.
20.)Connect the buckles and tighten the belt. Verify that the Color Video Printer is secure.
21.)Re-install the Connectors Panels Cover as described in
8-2-5-4 "Connector Panels Cover
Installation Procedure" on page 8-8
.
22) Reconnect the mains AC power cable from the wall outlet.
23) Turn ON the main circuit breaker located on rear of the Vivid 3N.
24) Turn ON the Vivid 3N by pressing the ON/OFF button on the Control Console.
25.)Select the activation key under System Configuration, VCR/ECG Tab, A/B Swap.
By default, Print B key will be B&W Video printer and Print A key will be Color Video printer. For
more information on switching printer settings, see
3-8-9 "VCR/ECG Tab" on page 3-44
.
See also the
8-8-4-8 "Color Video Printer Settings" on page 8-141
.
Figure 8-122 Color Video Printer Connection Cables
Power cord:
To: Color Video Printer
AC IN
R, G, B and SYNC cables:
To: Color Video Printer
INPUT R, G, B and SYNC
BNC Connectors
Model
UP-2950MD
only
REMOTE cable:
To: Color Video Printer
REMOTE 2 Connector