GE H
EALTHCARE
D
IRECTION
FC091194, R
EVISION
11
V
IVID
7 S
ERVICE
M
ANUAL
Chapter 3 - System Setup
3 - 19
3-6-3
Connections on the External IO
3-6-3-1
Connect Footswitch
Connect the Footswitch to the External I/O at the rear side of Vivid 7. When not in use, store it in the
tray below.
3-6-3-2
Connect Ethernet
Connect Ethernet to the External I/O at the rear side of Vivid 7.
3-6-3-3
Connect USB Flash Card
NOTE:
Support for USB Flash Card was introduced in software version v4.0.
NOTE:
USB Flash Cards approved for Vivid 7 are verified for EMC performance according to EN55011
class B. The use of any other USB Flash Cards will compromise this verification, and may cause
interference on Vivid 7 itself, or on other electronic devices. For approved models, see:
9-54 "USB Flash Card (USB Drive)" on page 9-67
.
Install the USB Flash Card in (one of) the USB port(s) on the front of Vivid 7.
•
Vivid 7 with BEP4.x has one USB 2.0 port on the front.
•
Vivid 7 with BEP3.x has two USB 2.0 ports on the front.
The port at the rear of the system, is USB 1.1, and is not approved for use by the USB Flash Card.
Figure 3-5 Footswitch connection
Figure 3-6 Ethernet connection
Footswitch connection
Ethernet connection
Summary of Contents for Vivid 7
