GE H
EALTHCARE
D
IRECTION
FQ091013, R
EVISION
1
V
IVID
I
N
AND
V
IVID
Q
N S
ERVICE
M
ANUAL
Chapter 8 - Replacement Procedures
8-23
8-2-6-5
LCD Display Cover Hinges Installation Procedure
NOTE:
When installing the replacement hinges, apply a coating of Loctite 242 glue to each of the
8 screws, as and when these are returned to their respective locations.
1.) While supporting the LCD Display cover with one hand, carefully place a replacement hinge in the
correct position on the
Left
side of the LCD Display cover (refer to
).
2.) Carefully place a replacement hinge in the correct position on the
Right
side of the LCD Display
cover (refer to
NOTE:
The cover has a degree of sideways free play i.e. it can slide from left to right on the hinges’
axle. The hinges on the right-hand side must be aligned with the holes in the Bottom Assembly
as explained in the next step.
3.) Gently maneuver the LCD cover by raising and lowering it while exerting pressure to slide the
LCD Display Cover until the hinge holes are aligned with the Bottom Assembly screw holes - see
right hinge in
.
NOTE:
The axle hinges should be adjusted so that on each hinge, the axle should protrude equally as shown
in
.
4.) On the
Left
hinge: return and fasten the 2 screws (previously removed) to the Bottom Assembly,
making sure the hinge is properly secured.
Do not over-tighten the screws
. Refer to
5.) On the
Right
hinge: return and fasten the 2 screws (previously removed) to the Bottom Assembly,
making sure the hinge is properly secured.
Do not over-tighten the screws
. Refer to
NOTICE
It is important to properly adjust the alignment of the LCD cover with the Bottom Assembly,
before returning the previously-removed parts, as described below.
Figure 8-28 Equal Protrusion of Axles on Hinges
On each hinge, the axle should protrude
equally as shown in the picture on the left.
Maneuver the LCD Display Cover by
raising and lowering it while gently exerting
pressure in the desired direction.
Summary of Contents for Vivid in
Page 2: ......
Page 30: ...GE HEALTHCARE DIRECTION FQ091013 REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL xxviii...
Page 739: ......
