GE
D
IRECTION
FQ091019, R
EVISION
2
V
IVID Q
N S
ERVICE
M
ANUAL
Chapter 3 - System Setup
3-83
4.) Right-click and select
Restart
to resume print job/s for printing, as required
3-9-4-4
Configuration of Peripherals on the SafeLock Cart
General Guidelines
1.) In
Standby
mode, no change should be made to USB-connected devices (regarding location,
introduction of new USB device, removal of a currently-connected USB device).
2.) USB devices should be connected and/or disconnected
only
in
Full Shutdown
or
Normal Scanning
mode.
3.) USB devices should
not
be connected and/or disconnected before completion of tasks assigned to
them.
4.) Whenever the Vivid q N ultrasound scanner is mounted on the SafeLock Cart,
always
use the
lower
USB port for the Hub.
5.) The Vivid q N ultrasound scanner and all connected devices working with scanner should be
powered and connected to the SafeLock Cart (
only
)!
For the SafeLock Cart, there are two basic peripheral configurations that are recommended:
Configuration - Recommendation 1
•
DVD always plugged into port 1 of the USB Hub
•
MOD always plugged into any port (recommended Port 2)
•
HP460 always plugged into any port (recommended Port 3)
•
B&W or Color printer (recommended Port 4)
Configuration - Recommendation 2
•
Memory Stick or HP460+Batt plugged directly into the upper USB port on the rear of the Vivid q N
ultrasound scanner.
Figure 3-82 Resuming Spooled Print Job
NOTICE
When using Peripherals on the Vivid q N SafeLock Cart, always observe the general guidelines listed
below.
