GE
D
IRECTION
FQ091019, R
EVISION
2
V
IVID Q
N S
ERVICE
M
ANUAL
3-136
Section 3-10 - Connectivity Setup
3-10-9
Using MPEGVue/eVue on a Remote PC
3-10-9-1
Installing MPEGVue on a Remote PC
When a DVD/CD containing MPEGvue exams is placed into a DVD/CD drive on a remote PC, it should
self-boot within a few seconds and display the Patient List.
The first time this is done on the remote PC there will be a one-time operation where the MPEGvue
program will self-install. If the remote PC operating system is Windows XP the installation is automatic
and, when completed, the Patient List on the DVD/CD will be displayed.
In the event that the remote PC operating system is Windows 2000, the auto-installation will display one
of the messages shown below (see
), requesting the user to download
and install some drivers.
The requested drivers may be downloaded from the Internet, or, if the DVD/CD was pre-configured,
those drivers will be located on the MPEGvue DVD/CD itself.
In addition to the above, the installation program will test the configuration of the remote PC and will
display a message if any component on the computer is not within the required specifications.
NOTE:
Only Windows 2000 and later supported.
http://www.microsoft.com/windows/ie/support/default.mspx
Figure 3-143 Download/Installation Message Examples #1
