GE
D
IRECTION
FQ091019, R
EVISION
2
V
IVID Q
N S
ERVICE
M
ANUAL
Chapter 8 - Replacement Procedures
8-23
5.) Detach the Rear Cover and Latch Assembly from the Bottom Assembly and remove.
6.) Loosen and remove the 2 screws that secure the
left
hinge to the LCD Display cover, then carefully
remove the hinge.
7.) Loosen and remove the 2 screws that secure the
right
hinge to the LCD Display cover, then
carefully remove the hinge.
8-2-6-5
LCD Display Cover Hinges Installation Procedure
NOTE:
When installing the replacement hinges, apply a coating of Loctite 242 glue to each of the
8 screws, as and when these are returned to their respective locations.
1.) While supporting the LCD Display cover with one hand, carefully place a replacement hinge in the
correct position on the
Left
side of the LCD Display cover.
2.) Carefully place a replacement hinge in the correct position on the
Right
side of the LCD Display
cover.
NOTE:
The cover has a degree of sideways free play i.e. it can slide from left to right on the hinges’
axle. The hinges on the right-hand side must be aligned with the holes in the Bottom Assembly
as explained in the next step.
3.) Gently maneuver the LCD cover by raising and lowering it while exerting pressure to slide the
LCD Display Cover until the hinge holes are aligned with the Bottom Assembly screw holes - see
right hinge in
.
4.) On the
Left
hinge: return and fasten the 2 screws (previously removed) to the Bottom Assembly,
making sure the hinge is properly secured.
Do not over-tighten the screws
. Refer to
5.) On the
Right
hinge: return and fasten the 2 screws (previously removed) to the Bottom Assembly,
making sure the hinge is properly secured.
Do not over-tighten the screws
. Refer to
6.) Check that when closing the LCD Display cover it aligns properly with the Bottom Assembly. If
necessary, make further adjustments.
7.) Return and fasten the 2 screws (previously removed) to each of the LCD hinges, making sure each
hinge is securely fastened to the Base Assembly.
Do not over-tighten the screws
.
NOTICE
It is important to properly adjust the alignment of the LCD cover with the Bottom Assembly,
before returning the previously-removed parts, as described below.
Figure 8-27 LCD Display Hinges Secured to Base Assembly - Location of Screws
