GE
D
IRECTION
FQ091019, R
EVISION
2
V
IVID Q
N S
ERVICE
M
ANUAL
Chapter 10 - Care and Maintenance
10-11
Table 10-7 Vivid q N System - General Cleaning
Step
Item
Description
1
LCD Display
Cover
On a weekly basis, moisten a soft, non-abrasive folded cloth or sponge with a mild, general
purpose, non-abrasive soap and water solution. (
Do not use any solution containing
abrasive powder or strong chemicals such as, acid or alkaline
). Squeeze excess liquid
from the cloth/sponge, them wipe down the top, front, back and both sides of the unit
.
Do not
spray any liquid directly onto the unit!
Rinse the cloth/sponge with clean running water and wipe the unit surfaces again.
Use a dry, soft, lint-free cloth to dry the unit surfaces.
Wait for the unit surfaces to dry completely.
Note: In the event that disinfection is required or any stubborn stains remain, remove them with
a soft, dust-free cloth on which a small quantity of isopropyl rubbing alcohol has been
absorbed, as described below for cleaning the Keyboard.
2
LCD Display
On a weekly basis, gently wipe the LCD Display with a dry, soft, lint-free non-abrasive folded
cloth.
Note: In the event that you see a scratch-like mark on the LCD Display, this may be a stain
transferred from the Keyboard or Trackball when the LCD Display Cover was pressed from the
outside. Proceed as follows:
Wipe or dust the stain gently with a soft, lint-free cloth moistened with water or a 70-30 mixture
of isopropyl alcohol and water that does not contain impurities. Wring out as much of the liquid
as possible then wipe the LCD Display again.
Do not let any liquid drip into the computer!
Be sure to dry the LCD Display before closing the cover.
3
Control Panel
and Keyboard
Control Panel:
On a weekly basis, moisten a soft, non-abrasive folded cloth or sponge with a 70-30 mixture
of isopropyl alcohol and water that does not contain impurities. (
Do not use any solution
containing abrasive powder or strong chemicals such as, acid or alkaline
). Squeeze
excess liquid from the cloth/sponge, them wipe down the Control Panel
.
Do not spray any liquid directly onto the Control Panel!
Use a dry, soft, lint-free cloth to dry the Control Panel.
Wait for the Control Panel surface to dry completely.
Keyboard:
Clean the keyboard as described (above) for cleaning the Control Panel.
Wipe the surface of the keycaps with the cloth, making sure that no liquid drips on or between
the keys. Allow to dry.
4
Probe Holders
Clean the probe holders with warm water and a damp cloth to remove all traces of gel
(soaking may be required to remove excess gel).
5
MOD
Clean the drive head and media with the vendor-supplied cleaning kit. Advise the user to
repeat this often, to prevent future problems. MOD disks must be stored away from dust and
cigarette smoke. Do not use alcohol or benzene to clean the MOD cartridge.
6
DVD - CDRW
Drive
Clean the drive head and media with the vendor-supplied cleaning kit. Advise the user to
repeat this often, to prevent future problems. CDs must be stored away from dust and cigarette
smoke. Do not use alcohol or benzene to clean the CD drive.
7
Peripherals
Clean the peripherals in accordance with the respective manufacturer’s directions.
