GE H
EALTHCARE
DRAFT
V
OLUSON
E8 / V
OLUSON
E6
D
IRECTION
KTD102576, R
EVISION
7
DRAFT (A
UGUST
23, 2012)
S
ERVICE
M
ANUAL
Chapter 3 - Setup Instructions
3-11
3-5-2
Connecting the Black & White Printer
1.) Power OFF/Shutdown the system as described in:
2.) Connect the Black & White printer according to connection scheme, see:
NOTE:
The B&W printer should be connected to the
USB3
port of the Voluson E8 / Voluson E6´s PC-part.
Location of the USB3 port depends on the installed PC-Motherboard.
3.) When all the cables are connected, press the Power ON switch on the Black & White printer.
4.) Power ON/Boot up the Voluson E8 / Voluson E6 system as described in
. All software drivers are pre-installed for the designated Black & White printer only.
5.) After physical connection to the Voluson E8 / Voluson E6 system, assign the printer to a remote key
(
P1
,
P2
,
P3
and/or
P4
) as described in
Section 3-7-5 "Remote Control Selection" on page 3-48
6.) Verify the correct settings in the printer “Properties”, see:
Section 3-7-4 "Adjustment of Printer
Please
Note
If the printer driver for the Mitsubishi P95D B&W printer is not pre-installed, install it manually by means
of the “Found New Hardware Wizard” and the printer driver disk which is included with this new printer.
WARNING
WARNING
!! WARNING:
After each installation, the leakage currents have to be measured according to
IEC 60601-1 respectively UL 60601-1.
Summary of Contents for Voluson E8
Page 2: ......
Page 11: ...GE HEALTHCARE VOLUSON E8 VOLUSON E6 DIRECTION KTD102576 REVISION 7 SERVICE MANUAL ix ZH CN KO...
Page 431: ......