UNPACKING THE WASHER
WARNING:
Recycle or destroy the carton
and plastic bags after the washer is unpacked. Make
materials inaccessible to children. Children might use
them for play. Cartons covered with rugs, bedspreads
or plastic sheets can become airtight chambers causing
suffocation.
1.
Cut and remove all packaging straps.
2.
While it is in the carton, carefully lay the washer on its
side. DO NOT lay the washer on its front or back.
3.
Turn down the bottom flaps. Remove all base packaging
including the styrofoam base.
4.
Carefully return the washer to an upright position and
remove the carton by lifting it upward.
5.
Carefully move the washer to within 4 feet (122cm)
of the final location.
6.
Remove the following from the back side of the washer:
5 bolts
5 plastic spacers (including rubber grommets)
7.
Insert shipping bolt hole covers into shipping bolt holes.
NOTES:
• Failure to remove the shipping braces can cause
the washer to become severely unbalanced.
• Save all bolts for future use.
•
If you must transport the washer at a later date, you must
reinstall the shipping support hardware to prevent shipping
damage. Keep the hardware in the plastic bag provided.
Installation Instructions
15
UNPACKING THE WASHER (cont.)
