– 49 –
Note: The Phillips-head clamp screw on the tub
outlet hose uses reverse rotation to tighten or
loosen the hose. It is necessary to turn the Phillips-
head clamp screw clockwise to loosen the clamp.
14. Turn the Phillips-head clamp screw clockwise
to loosen the clamp that secures the tub outlet
hose to the outer tub.
15. Remove the tub outlet hoses from the tub and
the air chamber inlet hose:
a. Loosen the clamps and slide them back.
b. Carefully break each hose loose by inserting
a small fl at blade screwdriver under the
hose to break the seal.
c. Remove the hoses.
Note:
When installing the tub outlet hose, engage the
•
notch on the hose with the tab on the outer tub
before fastening the clamp.
When installing the air chamber inlet hose,
•
engage the tab on the hose with the notch on
the air chamber before fastening the clamp.
Tub Outlet
Hose
Air Chamber
Inlet Hose
Air Chamber
Notch
Tab
Notch
Tab
16. Remove the 10-mm hex head screw and washer
from the top of each damper. (See
Dampers
.)
17. Lift the rear of the tub assembly to maintain a
level position, then pull each damper straight
out from the outer tub.
18. Position the dampers parallel to the bottom of
the washer.
19. Lift the outer tub assembly up, then release the
2 suspension springs from the slotted plastic
inserts in the cabinet top braces.
20. Carefully remove the tub assembly out the front
of the cabinet, then place the tub assembly on a
protective surface with the air chamber at the 2
o'clock position, as shown below.
Dampers in Parallel Position
Air Chamber
(Continued Next Page)
