522-08U
Clip Corner
■
■
4.
Remove the evaporator fan/motor bracket assembly.
Remove fan support panel.
■
■
5.
Disconnect the drain pan heater leads. Remove drain
pan/heater assembly by pulling drain tube through the
freezer side wall. Discard entire assembly.
■
■
6.
Skip this step for TL Serial models produced after Oct.
1994. Insert the “Xmas” ratchet fastener plug into the
pink “female” lead. (This lead will not be used. )
■
■
7.
Remove foam behind the evaporator, at left rear corner.
Remove screw at the top left side of the evaporator. Pull
evaporator down and away from the ceiling.
■
■
8.
Pull off the styrofoam pieces on the right wall and front
right corner. Discard both pieces. Wipe walls and
compartment ceiling dry. Install insulated pieces as
marked for each location. Peel backing and press pieces
onto the right and left sides, rear and front. Next place
top ceiling piece, being sure not to cover mounting
screw hole on the left side.
Note:
The top, front and rear
front pieces are sized to fit 48" wide models. Cut along
dotted cut line for 36" and 42" models.
■
■
9.
Replace styrofoam
piece with new
foam piece sup-
plied. Position the
styrofoam against
the front inside
corner, flush with
the ceiling and front
wall.
■
■
10.
Cut a notch out of
the bottom corner
of the evaporator
header plate. This
will allow the new
drain pan to fit
evenly in that
corner.
PINK “FEMALE” SIDE
OF THE CABINET HARNESS
“XMAS” RATCHET
FASTENER PLUG
522-08C
Evaporator
Fan/Motor
Bracket
522-08V
Fan Support Panel
522-08Q
Remove
Foam
Block
Drain Pan
Wires
522-08AA
CAUTION:
Evaporator fins are
sharp! Wear protective gloves.
522-08S
INSULATION
HEATER
MELTED OR
DAMAGED FOAM
INSULATING
FOAM PIECE
EVAPORATOR
EYELET SCREW
522-08Z
Place front, back and
side pieces.
Place top piece last.
522-08K
EVAPORATOR
SCREW
522-08R
Installation Instructions
Page 2 of 4
70836-00