■
■
24.
Reinstall the evaporator fan/motor assembly. Check for
proper rotation and clearance.
■
■
25.
Reinstall freezer rear panel (plenum) and icemaker.
Check to be sure icemaker fill tube is positioned
correctly over the fill cup.
■
■
26.
Reinstall light shield or ice bucket depending on the
model.
FINAL INSTALLATION and CHECKLIST:
■
■
Again, check PermaGum seals on the heat exchanger, wire
grommet and drain tube hole on the machine compartment
side.
■
■
Check to be sure that drain tube is secured with clamps and
discharges into the compressor drain pan.
■
■
Connect power.
■
■
Install front grille panel cover.
■
■
Turn temperature control to position 5.
■
■
Wait to verify that evaporator fan is running. Allow several
minutes for the evaporator fan delay to reset.
HEATER
WIRES
WIRE TIE
BLUE
WIRE
MOTOR
ORANGE
JUMPER
WIRE
ORANGE
WIRE
MOTOR
ORANGE
JUMPER
WIRE
PINK
WIRES
(FEMALE
CONNECTOR)
REAR VIEW
522-08P
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
N.D. 522-08M 6/00
Installation Instructions
Page 4 of 4
70836-00
■
■
22.
Install insulation piece on the back side of the evapora-
tor fan support (trim on dotted line for 36" or 42"
models). Reinstall the panel.
■
■
23.
Dry the drain pan under the compressor in the machine
compartment. Fill squeeze bottle with tap water. Insert
bottle up and into the fan panel opening. Squeeze
about half of the water onto the evaporator. Check to
see if water flows into the compressor drain pan.
Continue adding water until it flows into the pan. If the
entire water bottle is needed to create the flow, the
drain pan is not installed at the correct slope and must
be repositioned.
DRAIN
PAN
EVAPORATOR
FAN ORIFICE
SQUEEZE
BOTTLE
522-08M
