UNPACKING SPACEMAKER
™
Remove tape and two corner pads from rear
bottom corners of appliance.
Using the four shipping corner posts, lay the
appliance on its left side so the shipping base does
not rest on the floor.
Remove the foam shipping pad.
Remove the washer shipping bolt using the ratchet
with 3/8
″
socket and remove the plastic spacer
block using the slip-joint pliers.
Return the appliance to the upright position
and locate it in the general area to be installed.
Provide enough space at the rear for installing
the water inlet hose.
Untape and open the washer lid.
Remove:
a.
foam tub blocking pad
b.
foam shipping blocks from rear of unit
c.
tape from dryer door
d.
foam dryer support pads
e.
inlet hoses
f.
From the back of the washer, remove only
the
WIRE
shipping clips that secure the drain
hose to the left side of the washer backsheet.
DO NOT REMOVE THE PLASTIC CLAMPS
on the
right side of the washer. These clamps form
a standpipe to prevent water siphoning.
7
6
5
4
3
2
1
2
Plastic spacer
block
Installation Instructions
Tub
blocking pad
Shipping
blocks
Shipping
clips
Rear vent
only
Drain hose
Shipping carton
corner posts
Foam
shipping pad
Mechanism
shipping bolt
Dryer
support pads
UNPACKING SPACEMAKER
™
(CONT.)
NOTE:
The tub blocking pad, shipping bolt and plastic
spacer should be retained for use if the appliance
is transported at a later date.
Form a “U” shape on the end of the drain hose with
hose pointed toward the drain. For an installation
requiring a longer drain hose, use WH41X0387
(approximately 112
″
). This drain hose attaches
directly to the pump and should be installed by
a qualified technician.
INLET HOSE CONNECTIONS
Remove the inlet hoses and rubber washers from
the plastic bag.
Install the rubber washers in each end of the inlet
hoses.
Carefully connect the inlet hose marked “HOT”
to the bottom outlet of the water valve. Tighten
by hand; then tighten another 2/3 turn with pliers.
Carefully connect the other inlet hose to the top
outlet of the water valve. Tighten by hand; then
tighten another 2/3 turn with pliers.
POWER CORD CONNECTION
SEE ELECTRICAL CONNECTION INFORMATION
9B
9A
9
8
