Action
Step
Insert the pipette into the probe sheath assembly through the threaded hole
in the probe sheath assembly end plug.
3
Inject the water into the probe sheath assembly.
Note:
The inserted water provides the steam inside the probe sheath assembly
during autoclaving.
4
Remove the pipette.
5
Verify that the O-rings are present on the probe.
6
Insert the probe into the probe sheath assembly through the threaded hole
in the probe sheath assembly end plug.
7
166
Xcellerex XDM 50-1000, XDUO 100-1000 mixers Operating Instructions 29251615 AD
6 Preparation
6.4 Prepare and install the probes
6.4.3 Autoclave probe sheath assembly
Summary of Contents for Xcellerex XDM Series
Page 2: ...Page intentionally left blank...
Page 6: ...Page intentionally left blank...
Page 320: ...Page intentionally left blank...
Page 321: ...Page intentionally left blank...
