Installation and Commissioning
Installing
24
Operating Instructions GEA Orbital Cleaner Jumbo 6
Edition 2016-05-24
Notes on Installation
Observe the following points before installing the cleaner:
•
Interrupt the power circuit and protect it from unauthorized switch-on.
•
Interrupt the cleaning medium supply line and secure the line against
being opened. There must not be any chemical cleaning medium in the
supply line.
•
Make sure that there are no foreign objects in the system.
•
Clean (rinse) the cleaning medium supply line before connecting the
cleaner.
Filter/Strainer
We recommend you should install a filter/strainer (0.5 mm mesh) in the CIP
supply line as close to the cleaning head as possible in order to protect the
cleaner from being blocked by particles or against damage.
Installing
CAUTION
Moving sharp-edged parts
Fingers can be caught between the teeth of moving, intermeshing gears.
Carry the cleaner using the eyebolt screwed into the T-piece underneath
the cylindrical body.
NOTE
Incorrect assembly and wrong tools
Damage to/deformation of the body
When screwing the cleaner into place and tightening it it is very
important that you use the flats provided on the inlet cap.
The cleaner must never be installed by using a chain or serrated jaw
type tool to turn the body.
Carry out the following steps:
1.
Hold the cleaner inlet by hand and screw it onto the threaded pipe
connection until it is tight.
2.
Connect all media supply lines.
Done.