7.6
Adjusting the Proximity Switch in the lantern of PMO Valve Type M/2.0
Fitting the proximity switch holder
Carry out the following steps:
1.
Position the nut (2) against the slot (4.1) in the lantern (4) from the inside and
hold it in position with a finger.
Fig.51
2.
Secure the sliding piece (1) with the countersunk screw (3). Pay attention that
the orientation is as shown in the diagram. The mounting hole (1.1) must face
in the direction of the housing (5).
3.
Tighten the proximity switch nut (2) with the countersunk screw (3).
Fig.52
®
Done.
Adjusting the proximity switch holder
Carry out the following steps:
1.
Screw the adjusting screw (6) into the proximity switch holder until it reaches
the upper edge of the balancer (7).
Fig.53
2.
By slightly slackening the countersunk screw, position the proximity switch
holder in the slot in the lantern so that the point of the adjusting screw (6)
rests on the shoulder of the upper balancer in the direction of the actuator (A).
Start-up
Adjusting the Proximity Switch in the lantern of PMO Valve Type M/2.0
430BAL010699EN_6
17.03.2022
73
Summary of Contents for T.VIS A-15
Page 6: ...430BAL010699EN_6 6 17 03 2022...
Page 116: ......
