Fig.64
2.
Lift the sensor module (9) off the base plate.
®
Done
10.5.6 Removing the logic element NOT (seal pack)
Requirement:
•
Logic element NOT is only provided in connection with the pneumatic block
T.VIS/NOT!
Carry out the following steps:
1.
Loosen the screws (67) and remove logic element NOT (64) with flat gasket
and adapter plate (64.1).
Fig.65
®
Done.
10.5.7 Fitting the Logic Element NOT (Sealing Package)
Requirement:
•
Logic element NOT is only provided in connection with the pneumatic block
T.VIS/NOT!
Carry out the following steps:
1.
Fit the logic element NOT (64) in the reverse order.
Maintenance
Dismantling the Control Top into its Components
430BAL010699EN_6
17.03.2022
89
Summary of Contents for T.VIS A-15
Page 6: ...430BAL010699EN_6 6 17 03 2022...
Page 116: ......
