GEAppliances EDW1500 Series, Owner'S Manual

Cycle Chart

Model

Cycle

Water Usage (gal.)

Cycle Time (min.)

GSD3200

Hot Start Option

1

3.4

26

Series

Pots & Pans

10.9

61

Normal Wash*

6.8

61

Short Wash*

6.2

48

Rinse Only*

4.5

13

Drying/Plate Warmer

0.0

30

EDW1500 Series

Hot Start Option

1

1.7

33

GSD4000 Series

Pots & Pans

10.9

71

GSD4100 Series

Heavy Wash

9.3

71

GSD4200 Series

Normal Wash*

6.8

71

China/Crystal

9.3

71

Short Wash*

6.2

58

Rinse Only*/Rinse & Hold*

3.0

13

Drying/Plate Warmer

0.0

30

* Normal Wash should be selected to run this cycle.

1

Hot Start Option adds water amount and cycle time shown when selected.

Note:

Not all models have every cycle listed.

Consumer Support

Tr

oubleshooting T

ips

Operating Instructions

Safety Instructions

Energy Options

HI TEMP

Provides extra heat for best performance. It is used best with heavily soiled dishes.

WASH (ON)

HI TEMP

Turns 

HI TEMP WASH 

off.

WASH OFF

(on some models)

HEATED DRY

Turns the heating element on for fast drying. This option will extend the time of your wash cycle. 

(ON)

Available on all wash cycles except 

RINSE ONLY

. Adds approx. 32 minutes to the cycle.

HEATED DRY

Turns 

HEATED DRY 

off

.

Dishes air dry naturally and energy is saved

.

OFF

(on some models)

Cycles

POTS & PANS/

For heavily soiled dishes or cookware with dried-on or baked-on soils. Everyday dishes may be included. 

HEAVY WASH

This cycle will not remove burned-on foods.

NORMAL WASH

For loads of everyday dishes, glasses and cookware with medium soils. 

NOTE:

Many dishes have lighter soil than normal. 

Choosing a cycle other than 

NORMAL WASH 

will save energy and water.

SHORT WASH

For quickly washing loads of everyday dishes with medium soils that have not dried on, such as loads consisting 
mostly of glasses.

RINSE ONLY

For rinsing partial loads that will be washed later. 

Do not use detergent.

PLATE WARMER

For warming clean dishes and serving plates. This cycle will take approximately 30 minutes.

HOT START

Preheats wash water to the correct temperature.

Start

Slowly turn the Dial to the 

START 

or 

ON 

position, or the selected cycle. Don’t turn it past the 

START, ON 

or cycle position, or you could accidentally miss a rinse.

There is a time delay between start-up and water fill so you will not hear any wash action right away. 

■

Latch the door to begin the cycle.

Control Settings 

GEAppliances.com

5