Installation Preparation
2
PARTS SUPPLIED:
Two #8-18 x 5/8" Phillips special head screws,
to secure dishwasher to underside of countertop
or to side of cabinets. (Taped to top or side of
dishwasher.)
Side and top trim pieces on some models
2 Side-mounting brackets with four #8 Pan-head
mounting screws (for non-wood countertops) on
some models
Drain hose
Clamp
MATERIALS YOU WILL NEED:
Ferrule, compression nut and 90
°
Elbow (3/8"NPT external
thread on one end, opposite end sized to fit water supply)
Thread seal tape
UL Listed wire nuts (3)
Materials For New Installations Only:
Air gap for drain hose, if required
Waste tee for house plumbing, if applicable
Electrical cable or power cord, if applicable
Screw type hose clamps
Strain relief for electrical connection
Hand shut-off valve (recommended)
Water line 3/8" min. copper or 1/2" min. plastic
(plastic must be tested for temperature and pressure)
Coupler for extending drain line, if applicable
TOOLS YOU WILL NEED:
Phillips head screwdriver
1/4" and 5/16" nutdriver
6" adjustable wrench
Level
Carpenters square
Measuring tape
Safety glasses
Flashlight
Bucket to catch water when flushing the line
15/16" socket (optional for skid removal)
Gloves
For New Installations Only:
Tubing cutter
Drill and appropriate bits
Hole saw set
90
°
Elbow,
Ferrule and
Compression Nut
Wire Nuts (3)
Waste Tee
Electrical Cable
(or Power Cord, if applicable)
Hot Water Line
Screw Type
Hose Clamps
Coupler
Hand
Shut-Off
Valve
Thread
Seal Tape
Side and Top Trim Pieces on some models
#8 Phillips
Special Head
Screws
5/8" long
#8 Phillips Pan-head Screws
3/8" long for side-mounting
on some models
Air Gap
Hole Saw Set
Measuring Tape
Tubing Cutter
Drill and Bits
Phillips
Head
Screwdriver
15/16" Socket
Safety Glasses
6"
Adjustable
Wrench
Bucket
Flashlight
Carpenters
Square
Strain Relief
Side-Mounting Brackets
on some models
Gloves
Level
Drain Hose
Clamp
1/4" and 5/16"
Nutdriver
