Toekick
Remove 2
Toekick Screws
White
Ground
Black
Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Small Hole in Bracket
Remove
Junction Box
Cover
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
Use UL Listed
Wire Nuts
A
B
C
D
Drain Hose
Hose
Clamp
Front of Dishwasher
90
°
Elbow
Thread Seal Tape
Fill
Hose
Water Valve
Bracket
Installation Instructions
6
• Connect incoming power cord white (or ribbed) to
dishwasher white, black (or smooth) to black and
ground to dishwasher green wire. Use UL listed
wire nuts of appropriate size.
• Replace junction box cover. Be sure wires are not
pinched under the cover.
STEP 4 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired or
has a factory installed power cord.
Use Power Cord Kit WX09X70910, available for
purchase from an authorized GE Appliance Dealer.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
• Maximum power cord
length is 6 feet.
Figure J
Figure I
STEP 3 REMOVE TOEKICK
• Remove the
2 toekick screws
and toekick.
Set aside for use
in Step 18.
STEP 5A INSTALL DRAIN HOSE
TO DISHWASHER
DRAIN PORT
Skip this step if drain hose has been pre-installed. In
this step you will need the drain hose set aside prior
to Step 1.
• Remove hose clamp attached to drain hose. Place
hose clamp over the small end of the drain hose.
Tip:
Prevent drain hose damage and possible leaks.
Be careful not to nick or cut the drain hose.
• Push the small end of the drain hose over the drain
port of the dishwasher, see Figure L.
• Make sure hose is fully seated on the dishwasher
drain port.
• Position hose clamp against the front lip of the drain
hose and tighten clamp.
Figure L
STEP 5 INSTALL 90
°
ELBOW
• Wrap 90
°
elbow with
thread seal tape.
• Install a 90
°
elbow onto
the water valve.
• Do not over tighten
90
°
elbow. Water
valve bracket could
bend or water valve
fitting could break.
• Position the end of the
elbow to face the rear
of the dishwasher.
Figure K
