Installation Instructions
7
STEP 9 INSTALL TRIM PIECES
Skip this step if trim is not supplied with the
dishwasher.
• Locate trim strips inside dishwasher.
• Press trim onto the tub flange on each side. Start with
the top edge, pressing on as you move towards the
bottom.
• Press the two top trim pieces on each side of the latch.
• Open and close the door to check that trim does not
bind and does not interfere with door latch.
Figure P
STEP 8 SLIDE DISHWASHER
PARTIALLY INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a
time.
• As you proceed, pull the drain hose through the open-
ing under the sink. Stop pushing when the dishwasher
is a few inches forward of adjacent cabinets.
• Make sure drain hose is not kinked under the dish-
washer and there is no interference with the water
line and wiring or any other component.
Do Not Push Against
Front Door Panel With
Knee. Damage to The
Door Panel Will Occur.
Figure O
Tip:
Position water line and house wiring on the floor
to avoid interference with base of dishwasher.
Figure N
STEP 7 INSERT DRAIN HOSE
THROUGH CABINET
• Turn the dishwasher upright and position in front of
the opening. Insert drain hose into the hole in
cabinet side. If a power cord is used, guide the end
through a separate hole.
Power Cord
(If Used)
Insulation
Blanket
Water
Line
Maximum Drain Hose
Length 10'
House
Wiring
Drain
Hose
Trim Strip
Trim
Strip
Trim
Strip
Top View
STEP 6 POSITION WATER LINE
AND HOUSE WIRING
• Position water supply line and house wiring on the
floor of the opening to avoid interference with base
of dishwasher and components under dishwasher.
Figure M
Water
Line
House
Wiring
5"
5"
4"
4"
6"
6"
4"
