Control settings.
Light
(on some models)
Press the button to turn on the light in the
dryer.
Press the button again to turn the light off.
This only controls the light when the door is
shut.
NOTE:
The light will turn off by itself after one
minute when the door is shut.
14
Lock Control
You can lock the controls to prevent any
selections from being made. Or you can lock
or unlock the controls after you have started a
cycle.
Children cannot accidentally start the dryer by
touching buttons with this option selected.
To lock the dryer, press and hold the
Lock
Control
button for 3 seconds.
To unlock the dryer controls, press and hold the
Lock Control
button for 3 seconds.
A sound is made to indicate the lock/unlock
status.
The indicator light above the button will
illuminate when the controls are locked.
NOTE
: The
Power
button can still be used when
the machine is locked.
15
16
17
eMonitor
(on some models)
The
eMonitor
lights display the relative energy
use of your selected cycle and options. They are
provided as an energy guide and range from
Good (1 light) to Better (5 lights). Cycle (time),
dryness level, temperature, and additional
tumble options can increase or decrease your
energy efficiency. Some cycles will not provide
a display.
18
Clean Filter Message
This message represents only a reminder and
does
not
always appear when the filter needs
cleaning. The filter should be cleaned after every
drying cycle is complete.
This message will disappear after the
Start/
Pause
button is pressed. Even though you may
have already cleaned the filter (before or after the
Power
button has been pressed), the “
Clean Filter
”
message will still be displayed until the
Start/
Pause
button is activated.
19
Display
Displays the approximate time remaining until
the end of the cycle.
As the cycle begins, you will see an initial
approximate total cycle time in the display.
Then lights will “race” in the display. This
means the dryer is continuously monitoring
the amount of moisture in the load. The lights
will continue until the dryer senses a low level
of moisture in the load. At that point, the dryer
will calculate and display the approximate time
remaining.
10
Volume
This button has two functions:
To change the loudness of the end of cycle
signal, press the button as many times as
needed to reach the desired volume. There are
four sound levels including OFF.
To turn the button sounds ON/OFF, press
and hold the button for 3 seconds (on some
models).
Summary of Contents for GFD49
