GEAppliances.com
Steam Refresh Cycle
For slightly wrinkled dry garments. Significantly
reduces wrinkles on up to 5 garments. After the
Steam Refresh
Cycle, the unit will beep and display
“0:00.” If the unit is not turned off or if the door is
not opened, the dryer will continue to tumble for
30 minutes. At the end of 30 minutes, it will display
“0:00” and the cycle will be complete.
NOTE:
A single extremely light fabric item may need
to have an additional item included to achieve
optimum results.
8
Detangle
(on some models)
Activates alternating forward and reverse tumbling
to reduce tangling, dry more evenly, and improve
drying times. Typical loads such as bed and bath
mixed loads, where sheets, towels and pillow cases
are laundered together, benefit from this capability.
When the dryer reverses direction, there will be a
slight pause and sound change. This is normal.
NOTE:
Detangle
is selected by default for
Towels/
Sheets
and
Bulky/Bedding
cycles.
9
9
eDry
Reduces the total energy consumption of specific
dryer cycles by adjusting certain heat settings.
NOTE: Cycle times will change when e-Dry is
selected.
This cycle can be used with
Cottons
,
Normal
,
Active
Wear
,
Delicates
,
Speed Dry
,
Bulky
,
Towels-Sheets
,
Sanitize
and
Steam Dewrinkle
.
10
Extended Tumble
Minimizes wrinkles by adding approximately 60
minutes of no-heat tumbling after clothes are
dry. The beeper will sound every five minutes as a
reminder to remove the clothes.
The estimated time remaining display will show
“0:00”.
The extended tumble time does not get added to
the cycle time on the display.
11
Damp Alert
This option causes the dryer to beep when clothes
have dried to a damp level. Remove items that you
wish to hang dry. The
Damp Alert
will only beep
when this option is selected, and the dryer will
continue to dry.
Removing clothes and hanging them when they are
damp can reduce the need to iron some items.
12
Delay Dry
Use to delay the start of your dryer.
1. Choose your dry cycle and any options.
2. Press
Delay Dry
. You can change the delay time
in 1 hour increments, using the
Delay Dry
button.
3. Press the
Start/Pause
button to start the
countdown.
NOTE:
If the door is opened while the dryer is in
Delay Dry
, the countdown time will not restart
unless the door is closed and
Start/Pause
button
has been pressed again.
13
Delay Dry
Delay Dry
(Depending
on model)
Summary of Contents for GFD49
