20
TRANSFER REFRIGERATOR
DOOR HANDLE TO THE RIGHT
To remove the handle:
Remove the plug button by
carefully prying under the edge with a putty knife.
Remove the exposed screw holding the handle.
7
Remove the two screws holding the handle to the
top of the door.
After removing the handle:
Move the small plug
buttons from the top right side of the door top and
insert them into the holes on the opposite side.
Small Plug
Buttons
Move the large plug button from the left edge of the
door and insert it into the hole on the opposite side.
Plug Button
Handle
Plug
Handle
Plug
Pin
Hole
Handle Plug
Short
Screw
Short Handle
Long Handle
REVERSING THE DOOR SWING
(CONT.)
Installation Instructions
TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove the center hinge bracket by removing
the three screws.
NOTE:
Keep these screws with the hinge bracket.
They are long screws and will be used when installing
the hinge on the other side.
You will need to remove the color-matched cap from
the screw head before you can remove the screw.
Use the edge of a thin flat blade to gently pry the
caps off the screw heads. (A putty knife works well
for this.) Cover the blade with tape to prevent
scratching the paint.
Remove the mullion cover from the left side using
the thin flat blade. Assemble it to the right side.
Remove the screw from the center left side of the
cabinet. Screw it into the holes on the right side.
Place the center hinge bracket over the holes at
the center left side of the cabinet. Insert and
tighten the three long screws.
Replace the cap by snapping it over the screw with
your finger.
5
TRANSFER DOOR STOPS
On each door, move the metal door stop from the
right to the left.
Move any screws from the left to the right.
6
Screw Cap
Mullion Cover
