Safety Instructions
Operating Instructions
Care and Cleaning
Troubleshooting T
ips
Consumer Support
11
Cleaning the glass cooktop surface.
(on some models)
www.GEAppliances.com
Normal Daily Use Cleaning
ONLY
use the recommended cleaning
cream, Cerama Bryte®, on the glass
surface. Other creams may not be as
effective.
To maintain and protect your glass
surface, follow these steps.
Before using the cooktop for the
first time, remove the burner
grates and vent grille, and clean
the glass surface with the cooktop
cleaning cream.
This helps protect the top and
makes clean-up easier.
Daily use of the cooktop cleaning
cream will help keep the glass
surface looking new.
Shake the cleaning cream well.
Apply a few drops of the cream
directly to glass surface.
Use a paper towel or sponge to clean
the entire glass surface.
NOTE:
It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
Burned-On Residue
WARNING:
DAMAGE to your glass surface
may occur if you use scrub pads other than BLUE
Scotch-Brite
®
Multi-Purpose No Scratch scrub
sponges by 3M.
Allow the glass surface to cool.
Remove the burner grates and
spread a few drops of Cerama Bryte
®
over the entire burned residue area.
Using the scrub sponge, rub the
soiled area. Apply pressure, as
needed, while rubbing with the pad.
If any soil remains, repeat the steps
listed above as needed.
For additional protection, after
all residue has been removed,
polish the entire glass surface with
Cerama Bryte
®
and a paper towel.
NOTE:
Razor blade is packed
inverted for safety reasons. Prior
to use, the blade must be rotated
and reinserted into slot. Do not
use a dull or nicked blade.
The RAZOR SCRAPER is available
through our Parts Center. See
instructions under “To Order Parts”
section on next page.
Clean your cooktop after each spill.
Heavy, Burned-On Residue
Allow the cooktop to cool.
Remove the burner grates and
spread a few drops of Cerama Bryte
®
over the entire burned residue area.
Hold scraper at approximately a 45°
angle against the glass surface and
scrape the soil. It will be necessary to
apply pressure to the razor scraper in
order to remove the residue.
Keep a small amount of cream on
the soil as you scrape.
After scraping with the razor
scraper, use the scrub sponge to
remove any remaining residue.
For additional protection, after all
residue has been removed, polish the
entire glass surface with Cerama Bryte
®
and a paper towel.
Scotch-Brite
®
Multi-Purpose
No Scratch scrub sponge
