Using the self-cleaning oven.
(This feature is not available for the lower oven.)
The oven door must be closed and all controls must be set correctly for the cycle to work properly.
Before a Clean Cycle
The oven must be cool in order to set the
self-clean cycle.
We recommend venting your kitchen
with an open window or using a
ventilation fan or hood during the
first self-clean cycle.
Remove the broiler pan, broiler grid,
all cookware and any aluminum foil
from the oven.
The oven shelves can be self-cleaned,
but they will darken, lose their luster
and become hard to slide.
Do not use abrasives or oven cleaners.
Clean the top, sides and outside of the
oven door with soap and water.
Make sure the oven lightbulb cover
(on some models) is in place and the
oven light is off.
IMPORTANT:
The health of some birds
is extremely sensitive to the fumes given
off during the self-cleaning cycle of any
oven. Move birds to another well
ventilated room.
Wipe up heavy soil on the oven
bottom. (appearance may vary)
How to Set the Oven for Cleaning
Press the
SELF CLEAN
pad.
Using the
HOUR
and
MIN +
or
–
pads, enter the desired clean time, if
a time other than 4 hours is needed.
Clean cycle time is normally 4 hours.
You can change the clean time to any
time between 3 hours and 5 hours,
depending on how dirty your oven is.
Press the
START
pad.
The door locks automatically. The display
will show the clean time remaining. It will
not be possible to open the oven door
until the temperature drops below the
lock temperature and the
LOCKED
light
goes off.
When the
LOCKED
light is off, open
the door.
■
The word
LOCK
will flash and the oven
control will signal if you set the clean
cycle and forget to close the oven door.
■
To stop a clean cycle, press the
CLEAR/OFF
pad. When the
LOCKED
light
goes off indicating the oven has cooled
below the locking temperature, open
the door.
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
16
