Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Problem
Possible Causes
What To Do
Surface units will not
Improper cookware
•
Use pans which are flat and match the diameter of
maintain a rolling boil
being used.
the surface unit selected.
or cooking is not
In some areas, the power
•
Cover pan with a lid until desired heat is obtained.
fast enough
(voltage) may be low.
Surface units do
A fuse in your home may be
•
R
Surface units do not
work.
There has been a main
power supply surge and/or
a power interruption and
surge.
•
•
•
On the Control Panel, activate the Self Clean mode
(press the SELF CLEAN button).
Wait for 30 seconds and then press the OFF button.
The cooktop should now be ready to operate.
eplace the fuse or reset the circuit breaker.
not work properly
blown or the circuit breaker
tripped.
Cooktop controls
•
Check to see the correct control is set for the surface
improperly set.
unit you are using.
Surface unit stops
This is normal. The unit
glowing when turned
is still on and hot.
to a lower setting
Scratches (may appear
Incorrect cleaning
•
Scratches are not removable. Tiny scratches will become
as cracks) on cooktop
methods being used.
less visible in time as a result of cleaning.
glass surface
Cookware with rough bottoms
•
To avoid scratches, use the recommended cleaning
being used or coarse particles
procedures. Make sure bottoms of cookware are clean
(salt or sand) were between
before use, and use cookware with smooth bottoms.
the cookware and the surface
of the cooktop.
Cookware has been slid
across the cooktop surface.
Areas of discoloration
Food spillovers not cleaned
•
See the Cleaning the glass cooktop section.
on the cooktop
before next use.
Hot surface on a model
•
This is normal. The surface may appear discolored
with a light-colored cooktop.
when it is hot. This is temporary and will disappear
as the glass cools.
Plastic melted to
Hot cooktop came into
•
See the Glass sur
face―po
tential for permanent damage
the surface
contact with plastic placed
section in the Cleaning the glass cooktop section.
on the hot cooktop.
Pitting (or indentation)
Hot sugar mixture spilled
•
Call a qualified technician for replacement.
of the cooktop
on the cooktop.
Frequent cycling
Improper cookware
•
Use only flat cookware to minimize cycling.
off and on of
being used.
surface units
Oven light does
Light bulb is loose.
•
Tighten or replace the bulb.
not work
Oven will not work
Plug on range is not completely
•
Make sure electrical plug is plugged into a live, properly
inserted in the electrical outlet.
grounded outlet.
A fuse in your home may
•
Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
Oven controls improperly set.
•
See the Using the oven section.
Oven too hot.
•
Allow the oven to cool to below locking temperature.
38
Before You Call For Service…
Co
ns
um
er
S
upp
or
t
Tr
ou
bl
es
hooti
ng
Ti
ps
Ca
re
a
nd
C
le
an
in
g
O
pe
rati
ng
In
str
uctio
ns
Saf
et
y
In
str
uctio
ns
Summary of Contents for PCB900
Page 46: ...46 POSTALCODE POSTAL PROVINCE ...
