Replacing the light bulb.
Cooktop Lights/Nite Lights
Replace with 120 volt, 40 watt (max)
incandescent bulbs. Order WB25X10030 from
your GE supplier.
1
To replace the cooktop lights/nite lights, first
disconnect the power at the main fuse or
circuit breaker panel, or pull the plug.
2
One side at a time, remove the screw from
the side of the light compartment cover and
lower the cover until it stops.
3
Be sure the bulb is cool before removing.
Break the adhesive seal by gently
unscrewing the bulb.
4
Screw in the new bulb, then raise the light
cover and replace the screw. Repeat for the
other light. Connect electrical power to the
oven.
Remove screws.
About the exhaust feature.
Vent Fan
The vent fan has two metal reusable vent filters.
Models that recirculate air back into the room
also use a charcoal filter.
Reusable Vent Filters
The metal filters trap grease released by foods
on the cooktop. They also prevent flames from
foods on the cooktop from damaging the inside
of the oven.
For this reason, the filters must always be in
place when the hood is used. The vent filters
should be cleaned once a month, or as needed.
Reusable vent filters
(on all models).
Charcoal filter (on some models).
Replacing the Oven Cavity Lamp
1. Disconnect power at the main fuse or circuit
breaker panel.
2. Remove the top grill by removing the two
screws that hold it in place.
3. Remove charcoal filter if present.
NOTE:
Charcoal filter is an optional kit, you may not
have one.
4. Press the retainer holding the lamp shield in
place.
5. Pull the lamp shield out. Unscrew the
light bulb out and replace with the
120V-130V, 30W incondescent bulb. Order
WB25X10029 from your GE supplier.
6. Return the lamp and lamp shield to original
position and replace charcoal filter.
7. Replace the grill and 2 screws. Reconnect
power to the oven.
30
