Installation:
NOTE:
The pictures shown in the User’s Manual are for demonstration purposes only. Your computer or product may look slightly different.
1.
Remove the
Battery Compartment Cover
on the back of your Keypad, and install the enclosed battery into your Keypad following
the battery orientation guide in the battery bay, and then slide the cover back onto your Keypad until it securely locks.
2.
Turn on your computer, and wait for it to load.
3.
Plug the USB Receiver into an available USB port on your computer.
4.
Turn on the power switch on the back of your Keypad
•
, your keypad will establish a connection with the receiver and will be ready to
be used. If a connection is not established, there might be a high level of surrounding interference, press the
Connect
button on the
USB Receiver
‚
, and then press the
Connect
button on the bottom of your Keypad
ƒ
.
5.
Your computer will detect your Keypad, and the necessary drivers will be installed automatically.
6.
Your Keypad is now ready to be used.
