3
GEAR4 | SoundOrb Aurora | User Manual
■
Press on the Main Unit or remote control
to power on.
■
When your iPod / iPhone is docked, iPod
mode is automatically activated.
■
Connect the RCA cables to back of your TV
and then into the back of the Main Unit,
matching the yellow colour coded plug to the
yellow colour coded port on your TV (red and
white are for audio; yellow is for video).
■
Select the correct source / mode on your TV.
■
Browse your iPod / iPhone menus and press
on your iPod / iPhone or the remote control
to start playing your selected video on your TV.
N.B. Some iPod models require you to have
‘Video Out’ settings turned on or enabled.
Ad MuTE:
To minimise disruption from loud advertising
breaks, SoundOrb Aurora’s volume can be
reduced to a low level by one touch. To do this:
■
Press and hold MUTE on the remote control
for a few seconds, the volume level will be
reduced to volume ‘25’.
■
Press and hold MUTE again to return to your
original playing volume.
■
Tapping MUTE once will mute the volume
completely.
Sub-Woofer:
To control the Sub-Woofer volume:
■
Press SUB /- on the remote
control.
■
Press ‘3D’ and +/- at the same time on
the Main Unit.
RECOMMENdEd SuB-WOOFER
VOLuME SETTiNGS:
■
To maintain the balance between low level
bass-rich sound and higher, crisp notes,
you may want to decrease the Sub-Woofer
volume level if it is placed nearer to you
and increase the Sub-Woofer volume if it is
further away.
■
The volume of the Sub-Woofer should also
be adjusted to match your environment /
room, music and personal taste.
Ambient light function:
The Sub-Woofer has an adjustable ambient
light function, capable of cycling through a full
spectrum of colours.
■
To select the preferred mode, slide the switch
at the back of the Sub-Woofer.
■
The ambient light has 3 settings:
–
Off:
the ambient light function is disabled.
–
Glow:
the ambient light will cycle through
the full spectrum of colours. To set the
